Table of Contents
Advertisement
KV-DW36K9H
RM-970
4.
Self-diagnosis screen displays
•
In cases of malfunctions where it is not possible to determine the symptom such as when the power goes off occasionally or when
the screen disappears occasionally, there is a screen display on whether the malfunction occurred or not in the past (and whether
the detection circuit operated or not) in order to allow confirmation.
<Screen Display Method>
•
Quickly press the remote command button in the following order from the standby state.
Self-diagnosis screen display
2
:
+B OCP
3
:
+B OVP
4
:
V STOP
5
:
A K B
6
:
LOW B
7
:
H STOP
101 :
WDT
5.
After the self-diagnosis operation
•
The results display is not automatically cleared. In case of repairs and after repairs, check the self-diagnosis screen and be sure
to return the results display to " 0 ".
•
If the results display is not returned to " 0 " it will not be possible to judge a new malfunction after completing repairs.
<Method of Clearing Results Display>
1. Power off (Set to the standby mode)
2.
3. Channel 8 b
<Method of Ending Self Diagnosis Screen>
•
When ending the self-diagnosis screen completely, turn the power switch OFF on the remote commander or the main unit.
–
b
5
b
b
˘
Be aware that this differs from the method of
entering the service mode (
SELF CHECK
G
• "G" : OK, "NG" : DETECTS ONCE OR MORE
G
G
• THE 10 DIGITS OF NUMERALS ARE FOR CHECKING,
G
G
G
• 101 : NO LED BLINKING FOR WDT.
0
0 0 0 0 0
-
0 0 0 0 0
b
5 b
+ b
(Test reset = Factory preset condition)
+ ).
NO RELATION TO DIAGNOSIS.
"0" : NUMBER OF DETECTION.
(Service Mode)
– 6 –
Advertisement
Table of Contents
