wsm V3800-CR-TE4 Workshop Manual page 28

V3800-CR-TE4,V3800-CR-TIE4,V6108-CR-TIE4, WSM
Step3
1. Execute the request by the "DPF Manual Regeneration
Request Function" in the active test of the diagnosis tool, and
give the command to execute on the application side.
(When the execution button is not on the application side, ECU
on the application side receives the request signal and gives
command to execute.)
Step4
1. Check if the "DPF Regeneration Control Level" and the "DPF
Regeneration Control Status" shows "Level 0" by the monitor
functions in the diagnosis tool.
If the level is 0, it means that manual regeneration has
completed.
1-S20
ENGINE