Mounting Of Dpf Muffler Full Assy - wsm V3800-CR-TE4 Workshop Manual

V3800-CR-TE4,V3800-CR-TIE4,V6108-CR-TIE4, WSM

[11] MOUNTING OF DPF MUFFLER FULL ASSY

Follow the procedures below to mount DPF muffler full assy to a product (engine).
After mounting it, start up an engine and check gas leak.
Mounting of DPF Muffler Full Assy
1. Set chain sling by using shackle at two places (a) and (b) as
shown in the photograph.
2. Lift the DPF muffler full assy, and guide it to the installation
position.
3. Assemble the DPF muffler full assy with the mounting bolt of the
DPF muffler full assy (2) and the mounting bolt (1) on the
exhaust manifold side.
4. Remove chain sling.
NOTE
• When guiding the DPF muffler full assy to the installation
position, use caution so that the pressure pipe 1 (3) does
not hit the EGR pipe (4).
Mounting bolt of DPF muffler
full assy
Tightening torque
Mounting bolt
(Exhaust manifold side)
(1) Mounting Bolt
(2) Mounting Bolt of DPF Muffler Full
Assy
(3) Pressure Pipe 1
(4) EGR Pipe
Connector of Exhaust Temperature Sensor and DPF Stay 1
1. Install DPF stay 1 (5).
2. Connect connectors (1), (2), (3) of exhaust temperature sensor,
and fix wiring with clamps (4).
Tightening torque Stay mounting bolt
(1) Connector of Exhaust
Temperature Sensor T2
(2) Connector of Exhaust
Temperature Sensor T1
1-S15
ENGINE
49.0 to 55.9 N·m
5.00 to 5.70 kgf·m
36.2 to 41.2 lbf·ft
49.0 to 55.9 N·m
5.00 to 5.70 kgf·m
36.2 to 41.2 lbf·ft
(a) Shackle Set Position
(b) Shackle Set Position
49.0 to 55.9 N·m
5.00 to 5.70 kgf·m
36.2 to 41.2 lbf·ft
(3) Connector of Exhaust
Temperature Sensor T0
(4) Clamp
(5) DPF Stay 1