Honeywell GKP-S8M User Manual page 16

Depending on panel configuration a tamper alarm is sent to
the panel and there is a 120 second delay before transmitting
the specific tamper message to the monitoring station. If
tamper is restored before the end of the delay there is no
transmission (the tamper delay is only when the system is
disarmed. Tamper is immediately transmitted if the panel is
armed).
2. Remove the batteries and replace them with the new batteries.
3. Install the keypad on its bracket.
WARNING: RISK OF FIRE, EXPLOSION AND BURNS, DO NOT RECHARGE,
DISASSEMBLE, HEAT ABOVE 100° C, OR INCINERATE THE BATTERY. WHILE
THE BATTERY CAN NORMALLY BE SAFELY REMOVED BY HAND, CARE
SHOULD BE USED TO ENSURE THAT THE BATTERY TERMINALS ARE NOT
SHORTED, NOR THE BATTERY DAMAGED, DURING THE REMOVAL PROCESS.
DISPOSE OF DEPLETED BATTERIES BY COMPLYING WITH APPLICABLE
NATIONAL AND LOCAL REGULATIONS. IN THE EVENT OF THE BATTERY
BEING DAMAGED, USE PERSONAL PROTECTIVE EQUIPMENT TO REMOVE IT
IMMEDIATELY, AND DISPOSE OF IT IN A SAFE MANNER (REFER TO THE
BATTERY MANUFACTURER'S SPECIFICATIONS FOR SUCH SITUATIONS). FOR
SWITZERLAND, ANNEX 4.10 OF SR 814.013 APPLIES TO THE BATTERY
INCLUDED WITH THIS PRODUCT. THERE IS A RISK OF EXPLOSION IF THE
CORRECT BATTERY IS NOT USED. REPLACE ONLY WITH LITHIUM BATTERY
TYPE CR123A
Please contact your local authorized Honeywell representative for product warranty
information. All data and images in this document are subject to change without prior notice
15