Honeywell GKP-S8M User Manual page 12

To enable a user:
1. Press and hold the user number "0 to 9" key for 3 seconds.
A double beep is played and all status LEDs light on.
2. Enter the master code or present the master tag.
A high beep is played and all status LEDs start flashing.
3. Press the
The programming mode ends automatically.
4. After a few seconds, a double beep is played and all status
LED stop flashing.
Procedure Entering prog
Adjust beep
volume
Enable Chime
Disable Chime
Procedure Entering prog
Assign TAG
Changing
Code
Disabling
Code
Enable user
Disable user
key to enable the user.
User Programming Mode Summary
Command
Select the device
+
(for 2 sec)
several times
+
(for 2 sec)
+
(for 2 sec)
Master User Programming Mode Summary
Authorization
User key 0-9 Master code or
(for 3 sec) master TAG
User key 0-9 Master code or
(for 3 sec) master TAG
User key 0-9 Master code or
(for 3 sec) master TAG
User key 0-9 Master code or
(for 3 sec) master TAG
User key 0-9 Master code or
(for 3 sec) master TAG
Selection
Select level
1 to 7
Selection
Present TAG
New user's code New user's code
0000
(or 000000)
End
End
0000
(or 000000)
11