Keypad Tones - Honeywell GKP-S8M User Manual

Keypad tones

TOTAL SET
ARMING
PARTIAL
SET
ARMING*
ANNEX SET
ARMING
EXIT DELAY
ARMING
COMPLETE
ENTRY
DELAY
DISARMING
FAULT
ALERT
*Can be set to silent mode depending on configuration.
**Defined during installation.
Sequence of 3 modulated
sounds.
Duration: 4 seconds
Sequence of 2 modulated
sounds.
Duration: 2, 5 seconds
Upon arming...
One double beep per second
followed by faster double
beep for 10s and then 2s
continuous beep.
After closing the final door.
Three fast beeps
Upon entry...
One double beep per second
followed by faster double
beep for 10s and then 2s
continuous beep.
Long and continuous beep
Duration: 2, 5 seconds
2 times 7 fast beeps.
4 beeps upon alert...
sent via the keypad
When arming total set,
confirms that the control
panel has received a valid
code or TAG and is
preparing to arm total set.
When arming the partial or
annex set, confirms that the
control panel has received a
valid code or TAG and is
preparing to arm partial or
annex set.
Total and annex set arming:
beeps continue until final exit
door is closed.
Partial* set arming: beeps
continue for 30 seconds**
until partial set is armed.
When closing the final exit
door, confirms that the
system is armed.
This entry tone lasts for
30 seconds** after you open
the entry door. You should
disarm your system within
this time.
When Disarming, confirms
that the control panel has
been successfully disarmed.
This signal indicates a fault
in the system.
Confirms the transmission of
an alert to the alarm
company.
13