Troubleshooting - Sharp xg-p25x Operation Manual

Troubleshooting

Problem
Power cannot be turned on or
off using the POWER buttons
(ON/OFF) on the projector.
Cannot be operated by
remote control.
Cannot be operated by all
buttons of the projector and
remote control.
No picture and no sound.
Sound is heard but no picture
appears.
Color is faded or poor.
Picture is blurred.
Picture appears but no sound
is heard.
No OSD appears.
An unusual sound is occasion-
ally heard from the cabinet.
Maintenance indicator lights
up.
Picture noise appears.
480P images do not appear.
Image is green on INPUT 1 or
2 COMPONENT.
Image is pink (no green) on
INPUT 1, 2 RGB.
E-65
XG-P25X/CD (E)-g 65
• Keylock level is set to "Level A" or "Level B", preventing operation of some or all
buttons. (See page .)
52
• Check to see if the batteries are dead. If they are, replace with new ones. (See page
.)
13
• When the projector is set to slave, use the buttons on the master projector or change the
setting by RS-232C commands from the computer. (See page
• When using slave setting in combination with Keylock Level B, all the buttons on the
projector and the remote control are disabled. Use the SAPS or RS-232C commands to
release slave and Keylock setting and enable buttons to operate.
Without a computer, you can release slave and Keylock setting by entering the buttons
on the projector as follows.
ON → ENTER → ON → ENTER → ON → ENTER → MENU
However, this operation also releases the password set.
• Projector power cord is not plugged into the wall outlet.
• The bottom filter cover is not securely installed.
• Selected input is wrong. (See page
• Cables incorrectly connected to rear panel of the projector. (See pages
• Remote control batteries have run down. (See page
• Cables incorrectly connected to rear panel of the projector. (See pages
• "Contrast" and "Bright" adjustments are set to minimum position. (See page
• On-screen Display ("BLACK SCREEN") is turned off and Black Screen function is turned
on, creating a black image. (See page
• "Color" and "Tint" adjustments are not correct. (See page
• Adjust the focus. (See page
24
• Projection distance is too long or too short to allow for proper focus. (See pages
• Cables incorrectly connected to rear panel of the projector. (See pages
• Volume is set to minimum. (See page
• OSD Display is set to "Level A" or "Level B", preventing to display some or all On-screen
Displays. (See page .)
48
• If the picture is normal, the sound is due to cabinet shrinkage caused by temperature
changes. This will not affect operation or performance.
• Refer to "Lamp/Maintenance Indicators" on page
• Adjust the "Phase" setting. (See page
• Noise may appear when used with certain computers. Set the NOISE FILTER to ON
using the RS-232C command. (See pages
• Set the resolution mode to 480P. (See page
• Change the input signal type. (See page
Check
52
.)
31
.)
13
.)
32
.)
41
.)
.)
31
.
61
.)
43
– .)
68 70
.)
44
.)
41
02.3.19, 7:13 PM
.)
– .)
16 21
– .)
16 21
.)
41
– .)
25 29
– .)
16 21