Specifications - Shure PGX Quick Start Manual

SPECIFICATIONS

Working Range (Line of Sight)
100 m (300 ft)
Note: Actual range depends on RF signal absorption, re-
flection and interference.
RF Carrier Range
H6: 524–542 MHz, 30 mW
J6: 572.250–589.875 MHz, 30 mW
K5E: 606–630 MHz, 10 mW
L5: 644–662 MHz, 30 mW
P6: 702.200–719 MHz, 30 mW
R1: 800–820 MHz, 20 mW
T1: 846–865 MHz, 10 mW
Q8: 740–752 MHz, 10 mW
JB: 806–810 MHz, 10 mW
R14: 794–806 MHz, 20 mW
X5: 925–932 MHz, 10 mW
G4: 470.125–493.825 MHz, 30 mW
G8: 494.200–509.825 MHz, 30 mW
Note: varies by region
Audio Frequency Response
45–15000 Hz
Note: Dependent on microphone type
Total Harmonic Distortion (Ref. ±33 kHz deviation, 1 kHz
tone)
0.5%, typical
Dynamic Range
>100 dB, A-weighted
Operating Temperature Range
-18°C (0°F)– +50°C (122°F)
Note: Battery characteristics may limit this range.
Transmitter Audio Polarity
Positive pressure on microphone diaphragm (or positive
voltage applied to tip of WA302 phone plug) produces
positive voltage on pin 2 (with respect to pin 3 of low-
impedance output) and the tip of the high impedance 1/4-
inch output.
PGX1 Bodypack Transmitter
Audio Input Level
–10 dBV maximum, gain position = mic
+10 dBV maximum, gain position = 0dB
+20 dBV maximum, gain position = –10dB
Gain Adjustment Range
30 dB
Input Impedance
1 MΩ
RF Output Power
10–30 mW
varies by region
Pin Assignments
TA4M:
1: ground (cable shield)
2: + 5 V Bias
3: audio
4: Tied through active load to ground (On instrument
adapter cable, pin 4 floats)
Dimensions
108 mm x 64 mm x 19 mm (H x W x D)
Weight
81 g (3 oz.), without batteries
Housing
Molded polycarbonate case
Power Requirements
2 "AA" size alkaline or rechargeable batteries
Battery Life
up to 8 hours (alkaline)
6
PGX2 Handheld Transmitter
Audio Input Level
+2 dBV maximum, at –10 dB gain setting
–8 dBV maximum, at 0 dB gain setting
Gain Adjustment Range
10 dB
RF Output Power
10–30 mW
varies by region
Dimensions
254 mm X 51 mm dia. (10 X 2 in.)
Weight
81 g (10.2 oz.), without batteries
Housing
Molded PC/ABS handle and battery cup
Power Requirements
2 "AA" size alkaline or rechargeable batteries
Battery Life
up to 8 hours (alkaline)
PGX4 Wireless Receiver
Dimensions
40 mm X 181 mm X 104 mm (H x W x D)
Weight
327 g (11.5 oz.)
Housing
ABS
Sensitivity
-105 dBm for 12 dB SINAD, typical
Image Rejection
>70 dB, typical
Power Requirements
12–18 V DC @ 150 mA, supplied by external power supply
(tip positive)
Audio Output
Configuration
Impedance balanced
Audio Output Level (Ref. ±33 kHz deviation with 1 kHz tone)
XLR connector: –19 dBV (into 600 Ω load)
6.35 mm (1/4") connector: –5 dBV (into 3 kΩ load)
Impedance
XLR: 200 Ω
6.35 mm (1/4"): 1 kΩ
Pin Assignments
XLR: 1=ground, 2=hot, 3=cold
6.35 mm (1/4") TRS: Tip=audio, Ring=no audio,
Sleeve=ground
NOTE:
This Radio equipment is intended for use in musical
professional entertainment and similar applications.
This Radio apparatus may be capable of operating
on some frequencies not authorized in your region.
Please contact your national authority to obtain
information on authorized frequencies and RF
power levels for wireless microphone products.