Saeco D.A. 5P Instruction And Maintenance Manual page 42

English
6.5 Insertion of the Clock module
Danger
This operation should be carried out by the maintenance tech-
nician.
The "Clock Module" device manages the following functions:
- the times when free dispensing is performed;
- Vending machine start up and shutdown times;
- the times when discounts or price rises should be applied, and
their amount;
- cleaning frequency
The following operations should be performed to insert the module:
- disconnect the device from the power supply;
- open the vending machine door (ref. 29, fig. 1) and remove
the small door (ref. D, fig. 14);
- insert the module (ref. A, fig. 14) in the electronic board con-
nector.
Important
The module (ref. A, fig. 13) is inserted properly when the
reference mark is in the lower part (fig. 14).
- Re-fit the small door (ref. D, fig. 14).
- Re-close the door (ref. 29, fig. 1).
C
fig. 14
6.6 Insertion of the Nation key
Danger
This operation should be carried out by the maintenance tech-
nician.
The "nation key" contains the following data:
- Language used by the display.
- Software settings connected with the country of operation.
Important
The vending machine does NOT work without the "nation
key" inserted, it is therefore necessary to insert it.
After having inserted the "nation key", the machine will refuse
the introduction of keys for different countries.
10
To insert the nation key it's necessary to perform the following op-
erations:
- Disconnect the power supply.
- Open the vending machine internal access door (fig. 14).
- Insert the key (ref. B, fig. 14) in the electronic board connec-
tor.
- Re-close the door.
6.7
This operation should be carried out by the maintenance tech-
nician.
A serial port (ref. C, fig. 14) is installed beside the "clock module"
connector.
Through the serial port the vending machine may be connected to
a Personal Computer or to the devices supplied to the AUTHOR-
IZED SERVICE CENTRES in order to carry out inspections and
programming operations.
6.8
Separate the accessory drink labels supplied with the machine by
following the broken line.
Apply the adhesive prices on the drink labels.
Insert the tags in the special housings (fig. 15-16) through the slots
B
located in the internal part of the door (ref. 29, fig. 1).
A
D
fig. 15
fig. 16
Serial port connection
Danger
Affixing labels and stickers