Basic Specifications - Huawei AP3010DN-AGN Hardware Installation And Maintenance Manual

Huawei AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN
Hardware Installation and Maintenance Guide

1.3 Basic Specifications

Table 1-7 Basic specifications of the AP3010DN-AGN, AP5010SN-GN, AP5010DN-AGN,
AP6010DN-AGN, and AP6010SN-GN
Item
Technical
specifications
Power specifications
Issue 11 (2015-05-18)
NOTE
When the WDS/mesh function is enabled on an AP, the blinking frequency of its Wireless LED indicates
the receive signal strength on the WDS/mesh connection by default. After you connect an AP to a WDS/
mesh network, you can run the wifi-light { signal-strength | traffic } command on the AC to make the
Wireless LED blinking frequency indicate receive signal strength or service traffic rate.
l wifi-light signal-strength:
l If the mesh function is enabled on the AP, the blinking frequency of the Wireless LED reflects
the weakest signal strength of all neighboring APs.
l If WDS is enabled on an AP, the blinking frequency of the Wireless LED reflects the strength
of signals received from a WDS AP.
l If the AP works in leaf mode, the blinking frequency of the Wireless LED reflects the strength
of signals received from a middle AP.
l If the AP works in middle mode, the blinking frequency of the Wireless LED reflects the
strength of signals received from a root AP.
l If the AP works in root mode, the blinking frequency of the Wireless LED reflects the weakest
signal strength of middle APs.
l
wifi-light traffic: allows the Wireless LED to reflect the service traffic volume on the radio.
The Fat AP does not support WDS/Mesh functions; therefore, the Wireless indicator of the Fat AP does
not indicate the signal strength.
The AP6310SN-GN does not support WDS/mesh functions; therefore, the Wireless indicator of the
AP6310SN-GN does not indicate the signal strength.
Dimensions (H x W x
D)
Weight
System memory
Power input
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
50 mm x 180 mm x 180 mm
0.4 kg
l 256 MB DDR2
l 32 MB flash memory
l DC 12 V ± 10%
l PoE power supply: -48 V DC (in
compliance with IEEE 802.3af/at)
NOTE
The AP6010DN-AGN and AP6010SN-GN cannot
use the PoE power supply and DC power supply
simultaneously.
1 Indoor AP Overview
7