Additional Dtl; Skin Tone Dtl - Panasonic AJ-SPX900E Operating Instructions Manual

8-3-7 ADDITIONAL DTL

Items/ Adjustable
Data Saved Range
KNEE APE LVL OFF
1
2
:
S C U F E
5
CHROMA DTL OFF
1
:
5
S C U F E
DTL GAIN(+) –31
:
+00
:
S C U F E
+31
DTL GAIN(–) –31
:
+00
:
S C U F E
+31
DTL CLIP 00
:
63
S C U F E
DTL SOURCE (R+G)/2
(G+B)/2
2G+R+B /4
(3G+R)/4
R
G
S C U F E
H.DTL LINE MIX 1H
2H
S C U F E
CORNER DTL ON
OFF
S C U F E
<Note>
The items indicated by
SW( ) R/W in the <SD CARD R/W SELECT> screen. The items
without are the setting items for PAINT MENU LEVEL R/W.
Please refer to [8-7-2 SD CARD R/W SELECT] for more
information.
The ____ in the Adjustable Range column indicates the preset
mode.
Downloaded From CamcorderManual.com Panasonic Manuals
Remarks
Set KNEE APE LEVEL.
Set the chroma detail.
Detects the chroma edge and superimposes
it on Y to enhance H.DTL. A greater value
increases the correction.
Adjust the detail level toward + (upwards).
Adjust the detail level toward the –
(downwards).
Adjust the detail signal clip towards the +
direction.
Set the signal source for detail signal
components.
Set the scan line to generate the H.DTL
signal.
ON/OFF switching for CORNER DTL mode,
which enhances the resolution around the
screen perimeter.
are the setting items for PAINT MENU

8-3-8 SKIN TONE DTL

Items/ Adjustable
Data Saved Range
SKIN TONE ON Set the skin tone DTL to ON or OFF.
DTL OFF
S C U F E
SKIN TONE ON ON/OFF switching for ZEBRA within the
ZEBRA OFF SKIN TONE range.
S C U F E
SKIN DTL 0 Adjust the effect of SKIN TONE DTL
CORING CORING.
:
5
:
S C U F E 7
SKIN TONE Used when obtaining the target hue for
SKIN TONE DTL. Align the center marker
GET
and the target object with each other.
– – – – –
Y MAX 000 Set the maximum value of the brightness
signal to which SKIN TONE effect is
:
190
enabled.
:
S C U F E
255
Y MIN 000 Set the minimum value of the brightness
signal to which the SKIN TONE effect is
:
010
enabled.
:
S C U F E
255
I CENTER 000 Set the center position on the I axis (the
area where SKIN TONE is enabled).
:
022
:
S C U F E 255
I WIDTH 000 Set the area width where SKIN TONE is
enabled along the I axis above and below
:
010
the I CENTER.
:
S C U F E 255
Q WIDTH 000 Set the area width where SKIN TONE is
: enabled along the Q axis above and below
005
the I CENTER.
:
S C U F E 255
Q PHASE –128 Set the phase in the area where SKIN TONE
is enabled based on the Q axis.
:
+000
:
S C U F E +127
R-Y
Q-WIDTH
I-WIDTH
+ direction
I-CENTER
– direction
Q-PHASE
Remarks
Y
Y-MAX
B-Y
Y-MIN
= SKIN TONE AREA
0
107
8