Pioneer KEH-p4020 Operation Manual page 28

D,IN Rea(-mgunt
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 7)
Frame
~?'~~I /
Insert the release pin into the hole ill
/ the bollom of the frame and pull out
to remove the frame,
(When reattaching the frame. point
the side with a groove downwards
and attach
it)
Fig. 7
2. Fastening the unit to the factory radio mounting bracket.
(Fig. 8) (Fig. 9)
Select a position where the screw holes of the bracket and
the screw holes of the head unit become aligned (are fitted),
and tighten the screws at 2 places on each side. Use either
truss screws (5 x 8 mm) or flush surface screws
(5 x 9 mm), depending on the shape of the screw holes in
the bracket.
Fig.8
Screw
Dashboard or Console
Fig. 9
<.ENGLISH>
Ab9,~tJhe liJeing screws for the '(ont p;anel
If
you do not operate the Detaching and Replacing the Front Panel Function. use the sup-
plied fixing screws and fix the front panel to this unie
1. Attach the holder to the front panel.
Fig.10
2. Replace the front panel to the unit.
Fig. 11
3. Fix the front panel to the unit using fixing screws.
Fig. 12