Advertisement
With the vinyl facing upward and fiberglass against the top of the water
heater, place the head blanket on top of the water heater. Align pre-cut
openings in the head blanket with the water nipples, temperature and
pressure relief valve, and junction box of the water heater.
When
components on water heater align with corresponding pre-cut openings
in the head blanket, secure the head blanket to the insulation blanket
using the remaining tape. See below.
NOTICE
Not all models require the use of a piece of head insulation.
Reconnect discharge line to temperature and pressure relief valve as
shown below.
For information about the model
number, serial number and operating
characteristics of the water heater
carefully lift flap identified in the
previous figure to reveal the rating
plate. If additional information is
required, carefully remove the
insulation blanket. When finished,
replace insulation blanket in the
same manner as originally installed
or contact your plumbing
professional.
4
Advertisement
