Olympus FE-240/X-795 Advanced Manual page 27

PIXEL MAPPING
The pixel mapping feature allows the camera to check and adjust the CCD and
image processing functions. It is not necessary to operate this function
frequently. Approximately once a year is recommended. Wait at least one minute
after taking or viewing pictures to allow the pixel mapping function to perform
properly. If you turn the camera off during pixel mapping, start again.
Select [PIXEL MAPPING]. When [START] is displayed, press .
K/q
...................................... Turning on the camera with the K or q button
YES/ NO
This function is used to turn on the camera when K or q is pressed.
s
......................................................................Adjusting the monitor brightness
BRIGHT/ NORMAL
BEEP
.................................................... Adjusting the volume of operation sound
OFF (No sound)/ LOW /HIGH
8
............................................... Adjusting the volume of camera warning sound
OFF (No sound)/ LOW / HIGH
SHUTTER SOUND
OFF (No sound)/ LOW / HIGH
VOLUME
.................................................. Adjusting the volume during playback
SETUP
1
2 BEEP
3
SHUTTER SOUND
VOLUME
BACK MENU SET OK
..............................Adjusting the image processing function
when the buttons are pressed
........................Adjusting the volume of the shutter button
• Press ON to adjust the volume.
• You can adjust the volume to one of five levels or mute
the volume.
27
EN