Functional Description - Makita BTW200 Instruction Manual

(2) Avoid storing battery cartridge in a
container with other metal objects such as
nails, coins, etc.
(3) Do not expose battery cartridge to water
or rain.
A battery short can cause a large current flow,
overheating, possible burns and even a
breakdown.
5. Do not store the tool and battery cartridge in
locations where the temperature may reach or
exceed 50 C (122 F).
6. Do not incinerate the battery cartridge even if
it is severely damaged or is completely worn
out. The battery cartridge can explode in a fire.
7. Be careful not to drop or strike battery.
8. Do not charge inside a box or container of any
kind. The battery must be placed in a well
ventilated area during charging.
SAVE THESE INSTRUCTIONS.
Symbols
The following show the symbols used for the
equipment. Be sure that you understand their
meaning before use.
Ready to charge
Charging
Charging complete
Delay charge (Cooling)
Defective battery
Conditioning
Cooling abnormality

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
1
2
002306
Always switch off the tool before insertion or
•
removal of the battery cartridge.
To remove the battery cartridge, withdraw it from
•
the tool while sliding the button on the side of the
cartridge.
To insert the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can see
the red part on the upper side of the button, it is not
locked completely. Insert it fully until the red part
cannot be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone around
you.
Do not use force when inserting the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Charging
1
001336
1. Plug the battery charger into the proper AC
voltage source. Two charging lights will flash in
green color repeatedly.
2. Insert the battery cartridge into charger until it
stops adjusting to the guide of charger. Terminal
cover of charger can be opened with inserting and
closed with pulling out the battery cartridge.
5
1. Red part
2. Button
3. Battery cartridge
3
1. Terminal cover
2
2. Battery cartridge
3. Charging light
4. Battery charger
3
4