Setting Up The Refrigerator Doors; Removing The Front Leg Cover; Removing The Freezer Door - Samsung rs61681gdsr User Manual

- When ICE OFF blinks on the display panel,
reinsert the bucket and/or make sure it's
CAUTION
installed properly.
- When the door is open, the Ice and water
dispenser do not work.
- If you close the door hard, it may cause water
spilling over the ice maker.
- To prevent dropping the ice bucket, use both
hands when removing it.
- To prevent injury, be sure to clean up any ice or
water that may have dropped on the floor.
- Do not let the children hang on the ice dispenser
or on the bucket. They may get hurt.
- Be sure not to put your hand or any object into the
ice chute. It may cause personal injury or damage
mechanical parts.
SETTING UP THE
REFRIGERATOR DOORS
If your entrance won't allow the refrigerator to pass
easily through it, you can remove the doors.

Removing the Front Leg Cover

First, open both the freezer and refrigerator doors,
and then take off the front leg cover by turning the
three screws counter-clockwise.
Separating the Water Supply Line
from the Refrigerator
1. Remove two water lines (gray one is for ice and
the other one is for water) by pressing the coupler
( 1 ) and pulling the water line ( 2 ) away.
Be careful that the water tube match same
color.
DA68-02924A-06.indb 13 DA68-02924A-06.indb 13
Reattaching the Water Supply Line
1. The Water Line must be fully Inserted to the center
of transparent coupler to prevent water leakage
from the dispenser.
2. Insert the 2 clips in the install pack and check that
each clip holds the line firmly.
clip A (1/4") clip A (1/4")
(6.35 mm) (6.35 mm)
Do not cut the water line. Gently separate it
from the coupler.

Removing the freezer door

A few things to mention fi rst.
• Make sure that you lift the door straight up so the
hinges are not bent or broken.
• Be careful not to pinch the water tubing and wire
harness on the door.
• Place doors on a protected surface to prevent
scratching or damage.
1. With the Freezer door closed, remove the upper
hinge cover ( 1 ) using a screwdriver, and then
disconnect the wires by gently pulling them apart
( 2 ).
1
2
center of transparent coupler center of transparent coupler
setting up _13 setting up _13
2015. 6. 17. 2015. 6. 17. 2:48 2:48