Setting Up The Refrigerator; Removing The Freezer Door; Setting Up The Refrigerator Doors - Samsung RSG307 Series User Manual

SETTING UP THE
REFRIGERATOR
Now that you have your new Refrigerator installed
in place, you are ready to set up and enjoy the
features and functions of the appliance. By
completing the following steps, your Refrigerator
should be fully operational. If not, fi rst check the
power supply and electricity source or try the
troubleshooting section at the back of this user's
guide. If you have any further questions, contact
your Samsung Electronics service center.
1. Place the Refrigerator in an appropriate
location with reasonable clearance between
the wall and the Refrigerator. Refer to
installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure
the interior light comes on when you open the
doors.
3. Set the Temperature control to the coldest
temperature and wait for an hour. The Freezer
will get slightly chilled and the motor will run
smoothly.
4. After powering the Refrigerator, it will
take a few hours to reach the appropriate
temperature. You can store food and drinks
in the Refrigerator after the temperature is
sufficiently cool.
SETTING UP THE
REFRIGERATOR DOORS
If your entrance won't allow the refrigerator to
pass easily through it, you can remove the doors.
Separating the Water Supply Line
from the Refrigerator
1. Pull the two water lines (which are in the Fixer)
out to the front.
DA68-02500A-11.indb 07 DA68-02500A-11.indb 07
2. Remove two water lines (White one is for water
and the other one is for ice) by pressing the
coupler (1) and pulling the water line (2) away.
Make sure the color Make sure the color
of the water lines of the water lines
match. match.

Removing the freezer door

A few things to mention fi rst.
• Make sure that you lift the door straight up so
the hinges are not bent or broken.
• Be careful not to pinch the water tubing and
wire harness on the door.
• Place doors on a protected surface to prevent
scratching or damage.
1. Remove a screw on the upper hinge cover
(1). With the door open, disengage the two
locking tabs with a flat-head screw driver (2)
and remove it while the lifting up the rear of the
cover (3), and then disconnect the wires by
gently pulling them apart (4).
3
2. Removing the FIXER HINGE ,and next take off
the upper hinge. Be careful that the door does
not fall on you as you are removing it.
Be sure to keep track of all parts you are
removing.
English - 07
1
2
1
4
2
2013. 12. 2. 2013. 12. 2. 9:48 9:48