Code Theft Protection - Bosch CR24 Operating And Installation Instructions

38 | en

CODE theft protection

Your device is equipped with a four-digit code
number for protection against theft. This
number must always be entered whenever the
device has been separated from the operating
voltage of the vehicle. The code query is
disabled by default, but it can be switched on.
Note:
If the code query is activated, the
Code LED ? starts flashing if both
the device and the vehicle ignition are
switched off.
The code number is located in the
radio pass for your device.
Note:
Never keep the radio pass inside the
vehicle!
Switching code query on/off
(CODE)
f Press the MENU 7 button to open the
menu.
f Press the MENU 7 button repeatedly
until "CODE" appears in the display.
After about 2 seconds, "0000" appears on the
display, and you can enter the code:
Note:
If you enter an incorrect code
number, "ERROR" appears on the
display, after which "0000" is shown
again. You can make the entry two
more times. After the third incorrect
entry, the device is locked for 1 hour.
During this time, the display shows
7 620 210 016 | 11.2013
02_CR24_en.indd 38
CODE theft protection
"WAIT 1 HOUR". If you switch off the
device during this waiting period, you
will have to wait again for a full hour
after switching it on again.
f Press the station button 1 < repeatedly
until the first digit from your code number
appears on the display.
f Press the station button 2 < repeatedly
until the second digit from your code
number appears on the display.
f Press the station button 3 < repeatedly
until the third digit from your code number
appears on the display.
f Press the station button 4 < repeatedly
until the fourth digit from your code
number appears on the display.
Note:
As soon as you have selected a
position from the code number by
pressing the station button 1 - 4 < it
is also possible to set the code
number digits using the volume
control 1.
When the correct code number is shown on the
display,
f Hold down the station button 5 < for
longer than 2 seconds.
The display again shows "CODE" and the
current setting "ON" or "OFF".
f Turn the volume control 1 to the left or
right in order to switch code query on or
off.
In order to leave the menu
Robert Bosch Car Multimedia GmbH
20.11.13 16:54