Huawei AP6510DN-AGN Quick Start Manual page 14

AP Local Configuration
3. Configuring WDS
This section describes how to configure WDS parameters on an AP.
● Introduction to WDS
WDS enables multiple AP6510DNs to establish wireless links to connect two or more wired or wireless LANs. WDS-
enabled AP6510DNs can switch data packets between the LANs. WDS facilitates network deployment, and device
installation, and allows flexible networking.
● Configuring WDS
Most WDS parameters are configured on the AC. For details, see the AC configuration guides. On an AP, you can enable
or disable the radio indicator that indicates the signal strength of the last hop bridge, and configure the WDS keys.
● Enabling/Disabling the radio indicator that indicates the signal strength of the last hop bridge.
NOTE
By default, the radio indicator is enabled on an AP6510DN.
1. Use Telnet to log in to the AP from a PC.
login: admin
Password: // The default password is admin.
~ #
2. Enabling/Disabling the AP's radio indicator
Enterprise AP (config) # configure interface wireless 0 (1)
Enter Wireless configuration commands, one per line.
Enterprise AP (if-wireless 0(1)) # wds led flag 0 (1)
Please reboot the AP, configuration will take effect
3. Restart the AP to make the configuration take effect.
~ # reboot
● Configure the WDS key.
NOTE
By default, the radio indicator is enabled on an AP6510DN.
1. Use Telnet to log in to the AP from a PC.
login: admin
Password: // The default password is admin.
~ #
2. Configure the WDS key.
Enterprise AP (config) # configure interface wireless 0
Enter Wireless configuration commands, one per line.
Enterprise AP (if-wireless 0(1)) # wds psk 0 (1) 111111
111111.
3. Restart the AP to make the configuration take effect.
~ # reboot
NOTE
After the configuration is complete, run the reboot command to restart the AP.
// Enter the 2.4G 5G interface view.
// Enable/Disable the AP's radio indicator.
// Enter the 2.4G 5G interface view.
// Set the key type to hex (parse) and the key to
13