Table of Contents
Advertisement
5
When charging is complete, the green light will remain steady.
6
After unplugging the charging cable from the TASER CAM HD recorder, remember to replace the dataport
plug on the TASER CAM HD recorder to prevent damage from any debris or moisture.
Charging the TASER CAM HD Recorder Using the PC USB
Download Cable
Note: Do not connect the TASER CAM HD recorder to your computer until you have installed the Evidence Sync
software. See the Evidence Sync User Manual for information on installing the software.
1
Connect the USB download cable to the TASER CAM HD recorder.
2
Connect the USB download cable to the computer. Be sure to fully insert the cable into the USB port.
3
A green light near the TASER CAM HD lens will flash to indicate charging.
4
When the TASER CAM HD recorder is fully charged, the green light will remain steady.
5
After unplugging the cable from the TASER CAM HD recorder, remember to replace the dataport plug on
the TASER CAM HD recorder to prevent damage from any debris or moisture.
Notes:
• Never remove the TASER CAM HD recorder from the CEW while the safety is in the up (ARMED) position.
• Never remove the TASER CAM HD recorder from the CEW while the recorder is plugged into a computer.
• If the TASER CAM HD recorder is recharged while inserted in an CEW, the battery might not charge above 95
percent capacity. This is because the CEW consumes power while the battery is charging.
TASER CAM HD Recorder User Manual
Chapter 3: Charging the TASER CAM HD Recorder
7
Advertisement
Table of Contents
