Table of Contents
Summary of Contents for Taser 26810
- Page 1 TASER CAM HD Recorder User Manual Models 26810, 26820 IMPORTANT SAFETY INSTRUCTIONS Read all warnings and instructions. Save these instructions. The most up-to-date warnings and instructions are available at www.taser.com MMU0036 Rev: D...
-
Page 2: Table Of Contents
Further Reading Chapter 3: Charging the TASER CAM HD Recorder Charging the TASER CAM HD Recorder Using the Wall Power Charging Cable Charging the TASER CAM HD Recorder Using the PC USB Download Cable Chapter 4: Operating the TASER CAM System... - Page 3 TASER CAM HD Recorder User Manual Battery Replacing the TASER CAM Battery Chapter 8: CID Icons Chapter 9: Troubleshooting Troubleshooting the TASER CAM HD Recorder Contents...
-
Page 4: Chapter 1: Warnings And Cautions
Charge the Battery Before Use. The TASER CAM HD battery must be charged and functional prior to use. Be aware that a battery can fail to function, fail to charge, fail to maintain a charge, or deteriorate over time. Properly main- tain the battery and ensure that it is fully functional. -
Page 5: Safety Information: General Maintenance & Use
To charge the recorder, only use the approved TASER charging cables. Do not recharge the TASER CAM HD recorder out of the recommended temperature range of 32 °F to 104 °F (0 °C to 40 °C). -
Page 6: Safety Information: Loss Of Data
TASER CAM HD Recorder User Manual Avoid Exposure to Wet Conditions. If the TASER CAM HD recorder is drenched or immersed in water, seawater, or other liquid, DO NOT use the recorder until completing the procedure recommended in the current version of the TASER Instructor Training materials or the product manual. -
Page 7: Chapter 2: General Overview
There are 2 ways your agency may have configured your X2 CEW to work with the TASER CAM HD AS recorder. With one option, shut down will occur 5 seconds after a trigger-initiated energy burst, but ARC switch functioning will... -
Page 8: In The Box
Your CEW recognizes the TASER CAM HD AS as a unique type of battery pack which enables the automatic shut- down feature of the CEW. The CEW will indicate that this feature is enabled via a special TASER CAM HD AS icon in... -
Page 9: Chapter 3: Charging The Taser Cam Hd Recorder
Notes: • Ensure that you fully charge the TASER CAM HD recorder before the first use (before it is inserted into a CEW). • For any subsequent charging performed with the recorder inserted in the CEW, ensure that the safety switch is in the down (SAFE) position and that the cartridges are removed from the CEW. -
Page 10: Charging The Taser Cam Hd Recorder Using The Pc Usb Download Cable
• Never remove the TASER CAM HD recorder from the CEW while the recorder is plugged into a computer. • If the TASER CAM HD recorder is recharged while inserted in an CEW, the battery might not charge above 95 percent capacity. -
Page 11: Chapter 4: Operating The Taser Cam System
Install the Evidence Sync software on your computer, update the X2 CEW and TASER CAM HD devices’ firmware, and configure your TASER CAM HD recorder before attempting to use it with the CEW. See the Evidence Sync User Manual for more information. -
Page 12: Using The Taser Cam Hd Recorder
Using the TASER CAM HD Recorder The function and use of the CEW do not change with the addition of a TASER CAM HD recorder (unless you have installed a TASER CAM HD AS recorder; see Chapter 2: General Overview). However, there are a few points to... - Page 13 • Recharge the TASER CAM HD recorder before the remaining battery capacity is less than 40 percent. • Do not block the lens of the TASER CAM HD recorder. If the lens is blocked, the CID will flash. With a 2-handed hold, the user might unintentionally block the lens, particularly when wearing gloves.
-
Page 14: Chapter 5: Records
Downloading, Uploading, and Viewing Records Note: Video/audio records are stored in the TASER CAM HD recorder and firing record data are stored in the CEW. If transferring records separately, remember to download or upload firing records from the weapon before or after transferring video/audio from the TASER CAM HD recorder. -
Page 15: Chapter 6: Firmware Update
Chapter 6: Firmware Update It is important that your X2 CEW has firmware revision V03.022 or later when using it with the TASER CAM HD recorder. (See the Evidence Sync User Manual for information on firmware updates. See the applicable CEW user... -
Page 16: Chapter 7: Use And Care
• Keep the TASER CAM HD recorder dry. • Recharge the battery every 30 days or when the battery charge drops to 40%. If the TASER CAM recorder is not being used, it still needs to be recharged every 30 days. This is intended to maintain battery integrity. -
Page 17: Chapter 8: Cid Icons
Chapter 8: CID Icons A CEW equipped with a TASER CAM HD recorder may display one or more of the combinations of icons shown here. For information on other CID icons, see the applicable CEW user manual. The TASER CAM HD icon displays in the upper-left corner of the CID. -
Page 18: Chapter 9: Troubleshooting
The TASER CAM HD recorder is Contact TASER International. damaged. The TASER CAM HD recorder pow- The TASER CAM HD recorder is op- er runs down too quickly. erating in extremely cold condi- tions. The battery has had too many Replace the battery. - Page 19 TASER CAM HD Recorder Operating Manual Symptom Cause Possible Solution The CID battery icon is displaying a The TASER CAM HD recorder is not Fully insert the TASER CAM HD record- blinking exclamation point. making good contact with the CEW er into the CEW.
- Page 20 There is debris on the TASER CAM Clean the lens using a soft cloth. distorted. lens. The lens of the TASER CAM HD re- Contact TASER International. corder is scratched/damaged. The TASER CAM HD recorder is un- Contact TASER International.
- Page 21 Windex is a trademark of S.C. Johnson & Son, Inc. TASER, TASER CAM, X2, X26P, ® and © are trademarks of TASER International, Inc., some of which are registered in the US and other countries. For more information, visit www.taser.com/legal. All rights reserved. © 2016, TASER International, Inc.