Table of Contents
Advertisement
11 11
Appliance Setup
A. Remove Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
• Pull the four glass assembly latches out of the groove
on the glass frame. Remove glass assembly from the
appliance (see Figure 11.1).
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Figure 11.1 Fixed Glass Assembly
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath
the fi rebox.
• The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before fi nishing work on the whole hearth is
complete. Splatter guards may be factory installed
or accompany the door of the unit, depending on the
fi replace model. Splatter guards must be removed
before appliance is fi red.
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
Heat & Glo • SL-3X, SL-5X, SL-7X, SL-9X Installation Manual • 2372-980 Rev. C • 8/16
D. Setup Overview
These are common log and refractory instructions for
the SL-3X, SL-5X, SL-7X, and SL-9X models. All four
models use the same number of components, which are
scaled up or down in size, depending on the model of
fi replace installed. All sizes consist of fi ve logs and two
hearth components.
*The photos shown in these instructions depict an SL-7X.
E. Install Hearth Components, Teco-Sil,
Glowing Embers
Install Hearth Components
1. Remove the left and right hearth components from the
packaging and install as shown in Figure 11.2. Verify
that the left and right hearth components are pushed
fi rmly "down" into position. This is important to ensure
grout lines are positioned correctly.
Figure 11.2 Press Left Hearth Firmly Into Place
Install Standard Refractory
1. Remove left, right, back and top refractory pieces from
the shipping packaging.
2. Install the rear refractory by placing it into the bracket
located above the air passage. Push down on the panel
to ensure that the outer legs engage screw tips.
3. Gently push the back refractory toward the back of the
fi rebox until the refractory contacts the fi rebox.
Note: The SL-3X rear refractory will be a rectangular shape
without "legs." See Figure 11.3.
®
, Refractory and Logs
57
Hide quick links:
Advertisement
Table of Contents
