Decorative Front Finishing - HEAT GLO SL-3X Installation Manual

C. Decorative Front Finishing
Only decorative fronts certifi ed for use with this appliance
model may be used. Contact your dealer for a list of dec-
orative fronts that may be used. Once you have deter-
mined what kind of decorative front and fi nishing material
is going to be used on the fi replace, use the information
below which shows the decorative front models and the
non-combustible fi nishing material thickness allowed.
Note: Refer to Section 3 for individual decorative front
dimensions as installed on appliance.
Inside Fit - Firescreen Front (0-4 Inch Finishing)
DECORATIVE FRONT
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
Stop fi nishing material fl ush with fi replace surround opening.
Figure 10.8 Firescreen Decorative Front
Overlap Fit - ARC,CHA,HAL, & CHAF (0-4 Inch Finishing)
FINISHING MATERIAL
4 IN. MAXIMUM
THICKNESS
(Includes additional clearances to sides and top of decorative front)
Finishing material between 1 and 4 inches thick.
Refer to Section 3 for X and Y dimensions.
Figure 10.9 Overlap Fit Decorative Front (ARC, CHA, CHAF, HAL)
56 Heat & Glo • SL-3X, SL-5X, SL-7X, SL-9X Installation Manual • 2372-980 Rev. C • 8/16
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
FINISHING MATERIAL
4 IN. MAXIMUM
THICKNESS
DECORATIVE FRONT
Y
X
Adjustable Overlap Fit
FRONT FACE OF FIREPLACE
DECORATIVE FRONT
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
Figure 10.10 Overlap Fit Decorative Front
1 IN. MAX.
FINISHING MATERIAL
(TOP EDGE)