Table of Contents
Advertisement
STEP
2
STEP
3
Repeat the steps above to program another device for each of
STEP
4
the remaining HomeLink buttons.
3-5. Other interior features
Press and hold down one of the
buttons on the HomeLink
the button on the transmitter.
When the indicator light on the
HomeLink changes from a slow
to a rapid flash after 20 seconds,
you can release both buttons.
Test
the
operation
HomeLink by pressing the newly
programmed button.
If programming a garage door
opener, check to see if the garage
door opens and closes. If the
garage door does not operate, see
if your garage transmitter is of the
Rolling Code type. Press and hold
the programmed HomeLink but-
ton. The garage door has the roll-
ing code feature if the indicator
light (on the HomeLink ) flashes
rapidly for 2 seconds and then
remains lit. If your transmitter is the
Rolling Code type, proceed to the
heading "Programming a rolling
code system".
and
of
the
3
265
Advertisement
Table of Contents
