Polaris BRUTUS Owner's Manual page 86

Travel Direction And Engine Speed Control
System (Models HD And HD
Description
The travel direction control system on models HD and HD
requires regular inspection. See information below.
Inspect the travel direction control and engine speed control
system to ensure proper operation. Incorrect adjustment may
cause erratic travel / engine speed conditions.
WARNING
Avoid Serious Injury Or Death.
Failure to check or maintain proper operation of the travel control
system can result in an accident and lead to serious injury or death if
the travel control pedal or the engine speed control lever sticks during
operation. Always inspect the travel control pedal for free movement
and return to neutral before starting the engine and occasionally
during operation. Never start or operate this vehicle if it has a sticking
or improperly operating travel control pedal. Immediately contact your
dealer for service if travel control problems arise.
Inspection And Maintenance (For BRUTUS HD
And HD Models Only)
PTO
Position the utility vehicle on a
flat level surface. Put the gear
selector in PARK and stop the
engine. Exit the utility vehicle.
Check the travel control pedal
(Item 1) for excessive free play.
The correct amount of total free
travel on the travel control pedal
Only
PTO
PTO
1
is 7,6 mm (0.30 in).
The engine speed control lever
(Item 2) will be used to control
engine RPM. When on flat level
ground, with the travel control
pedal in neutral, move the gear
selector lever to low and move
the engine speed control lever to
high idle. If any vehicle move-
ment is detected, contact your
dealer for service.
When on flat level ground, the gear selector lever in Park,
press the travel control pedal to full forward, the engine speed
should be 3650 - 3750 RPM. Repeat with travel control pedal
fully in reverse, the engine speed should be 3650 - 3750 RPM
If the travel control pedal does not return to neutral unassisted
during normal operation, see your dealer for service.
Use the engine speed control lever (Item 2) and check the high
idle.
When on flat level ground, the gear selector lever in Park,
move the engine speed control lever (Item 2) to high idle. The
engine speed should be 3650 - 3750 RPM.
MAINTENANCE
2
85