Installing The Appliance; Changing Over The Door Hinges; Aligning The Appliance; Ventilation - Bosch KGN SERIES Installation Instructions Manual

en

Installing the appliance

Please fold out the illustrated last page.
Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e.g.
a cooker, radiator, etc. If installation next
to a heat source is unavoidable, use a
suitable insulating plate or observe the
following minimum distances to a heat
source:
3 cm to an electric cooker.
30 cm to an oil or solid fuel cooker.
Appliances with fitted handles must be
situated at least 55 mm from the wall on
the hinge side so that the door can be
opened by 90°.
6
Changing over the door
hinges
We recommend that you have the door
hinges changed over by our customer
service.
Before changing over the hinges, pull out
the mains plug or disconnect the fuse.
Attention! Carefully place the
appliance on its back.
Installation in numerical sequence.

1. Changing over the door hinges.

Fig. 1/A and 1/B
2. Changing the door handle.
Fig. 1/C

Aligning the appliance

Fig. 2
Place the appliance in the designated
location and align.
Adjust the height adjustable feet with
a screwdriver.

Ventilation

Fig. 3
The air on the rear panel of the appliance
heats up. The warm air must be able to
escape. Otherwise, the refrigerator must
work harder. This will increase the power
consumption.
Therefore: Never cover or block ventilation
openings!