Toshiba MV19L3C Service Manual page 11

2-11: S REEL/T REEL (Refer to Fig. 2-11)
1. Remove the S Reel and T Reel.
Remove the 2 Polyslider Washers 1.
2.
NOTE
1. Take care not to damage the gears of the S Reel and T
Reel.
2. The Polyslider Washer may be remained on the back of
the reel.
3. Take care not to damage the shaft.
4. Do not touch the section "A" of S Reel and T Reel. (Use
gloves.) (Refer to Fig. 2-11) Do not adhere the stains
on it.
5. When you install the reel, clean the shaft and oil it. (If
you do not oil, noise may be heard in FF/REW mode.)
6. After installing the reel, adjust the height of the reel.
(Refer to MECHANICAL ADJUSTMENT)
S Reel
(A)
1
2-12: PINCH ROLLER BLOCK/P5-3 ARM ASS'Y
(Refer to Fig. 2-12-A)
1. Remove the P5 Spring.
Remove the screw 1.
2.
Unlock the 2 supports 2 and remove the Cassette
3.
Opener.
4. Remove the Pinch Roller Block, Pinch Roller Arm
Spring, Pinch Roller Lever Ass'y and P5-3 Arm Ass'y.
P5 Spring
P5-3 Arm Ass'y
• Screw Torque: 5 ± 0.5kgf•cm
DISASSEMBLY INSTRUCTIONS
T Reel
(A)
1
Fig. 2-11
1
2
Cassette Opener
2
Pinch Roller Block
Pinch Roller Arm Spring
Pinch Roller Lever Ass'y
Main Chassis
Fig. 2-12-A
NOTE
1. Do not touch the Pinch Roller. (Use gloves.)
2. When you install the Pinch Roller Block, install as shown
in the circle of Fig. 2-12-B. (Refer to Fig. 2-12-B)
2-13: A/C HEAD (Refer to Fig. 2-13-A)
Remove the screw 1.
1.
2. Remove the A/C Head Base.
Remove the 3 screws 2.
3.
4. Remove the A/C Head and A/C Head Spring.
NOTE
1. Do not touch the A/C Head. (Use gloves.)
2. When you install the A/C Head Spring, install as shown
in Fig. 2-13-B. (Refer to Fig. 2-13-B)
3. When you install the A/C Head, tighten the screw (1)
first, then tighten the screw (2), finally tighten the screw
(3).
(1)
2
2
(2)
1
• Screw Torque: 5 ± 0.5kgf•cm (Screw 1)
Spring Position
2-14: FE HEAD (RECORDER ONLY) (Refer to Fig. 2-14)
Remove the screw 1.
1.
2. Remove the FE Head.
FE Head
• The FE Head is not installed on the Video Cassette Player.
• Screw Torque: 4 ± 0.5kgf•cm
Fig. 2-12-B
(3)
2
A/C Head
A/C Head Spring
A/C Head Base
Fig. 2-13-A
Fig. 2-13-B
1
Fig. 2-14