Samsung np-q1ex User Manual page 137

3
Enter a password, press <Enter>, re-
enter the password for confirmation,
and press <Enter> again.
You can use up to 8 alphanumeric
characters for a password but you
cannot use special characters.
4
When a message confirming the
password configuration appears in
the [Setup Notice] window, press
<Enter>.
The supervisor password has been
set. The supervisor password is
required to turn the computer on or to
enter System Setup.
Setting a User Password
Users can start the system with a user
password, but cannot enter the System
Setup. By doing this, you can prevent
other users from entering Setup.
Before configuring a user password, a
supervisor password must have been
configured. Deactivating the supervisor
password also deactivates the user
password.
In the Set User Password item, press
<Enter> and complete the procedures of
Step 3 of Setting a Supervisor Password.
Activating the Booting Password
Before activating the booting password,
a supervisor password must have been
configured.
Set the Password on boot option to
Enabled. From now on, system booting
will not proceed without the password.
137