IMPORTANT PRECAUTIONS – continued
PRECAUTIONS
Water Supply
(Cold Water Only)
• Water hose must be at least 3/4 inch in
diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by running
the water for one minute into an empty"
5-gallon container.
ASSEMBLY INSTRUCTIONS
4
Step 1 Align holes on adapter brackets
with the posts on pressure washer as
shown. Tighten the four screws.
Step 3 Tighten the two screws.
• The water supply temperature must not
exceed 104°F/40°C.
• Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
• Always prevent debris from being drawn into
the unit by using a clean water source.
Step 2 Before pressing down handle
onto top of adapter brackets, the hose/
cord caddy and trigger gun holder
must be on opposite sides.
Step 4 Slide the spray wand
extension into the gun. Turn the wand
collar onto the gun threads until tight.