4 Replacement Procedures
4.6
Optical Drive
Removing the Optical Drive
To remove the optical drive, follow the steps below and refer to figures 4-6 and 4-7.
CAUTION: Do not apply excessive force to the top of an optical drive.
1. Remove the following screws securing the optical drive.
• M2.5×4B FLAT HEAD screw
2. Slide the optical drive outward to disconnect it from the connector PJ1820 on the
system board.
4-16
M2.5×4B FLAT HEAD
Figure 4-6 Removing the optical drive
×2
Satellite M30 Maintenance Manual (960-455)
4.6 Optical Drive
Optical drive