Synology RackStation RS3614xs+ Quick Installation Manual page 10

Confirm New Memory is Recognized
After installing a new memory module in the RackStation, we recommended checking whether or not the system
recognizes the new memory.
To check the memory of the RackStation:
1 Start up your RackStation. (See "Start up the RackStation" for more information.)
2 Install DSM. (See "Chapter 3: Install DSM on RackStation" for more information.)
3 Log in to Synology DiskStation Manager (DSM) with an account belonging to the administrators group.
4 Check Total Physical Memory
If the RackStation does not recognize the memory or does not start up correctly, please make sure the memory
was correctly installed.
Remove RAM Module from RackStation
1 Follow steps 1 to 4 of "Install a RAM Module" to remove the cover from the RackStation.
2 To remove the RAM module, follow the steps below:
a Release the ejectors on the memory slot by pushing outwards simultaneously.
b Hold the memory module by the edges and remove it from the slot.
3 Replace the top cover, slide it into place, and tighten the two back screws.
10 Chapter 2: Hardware Setup
Main Menu System Information.
at >