Step 4. Performing Additional System Verification; Step 5. Stopping The Diagnostics - IBM pSeries 690 User Manual

Step 4. Performing Additional System Verification

To perform additional system verification, do the following:
1. Press Enter to return to the Diagnostic Selection menu.
2. To check other resources, select the resource. When you have checked all of the resources you need
to check, go to "Step 5. Stopping the Diagnostics."

Step 5. Stopping the Diagnostics

To stop the diagnostics, do the following:
1. To exit the diagnostics, press the F3 key (from a defined terminal) or press 99 (from an undefined
terminal).
2. If you changed any attributes on your ASCII terminal to run the diagnostics, change the settings back
to normal.
3. This completes the system verification. If you received an error code, record the code and report it to
the service organization.
If the server passed all the diagnostic tests, the verification process is complete and your server is ready
to use.
If you received an error code, record the code and go to the Eserver pSeries 690 Service Guide.
Chapter 8. Verifying the Hardware Operation
139