Operating Tips; Maintenance; Optional Accessories; Troubleshooting - DeWalt DCT410 Original Instructions Manual

4. Press the forward or back arrow to select NO or
YES.
5. Press the OK button to save changes and exit.

operating tips

• Use only D WALT 10.8 V lithium ion battery.
e
• E nsure the D WALT battery is in good working
e
condition. If the low battery indicator light on
the screen is flashing, the battery needs to be
recharged.
• To extend battery life, make sure to turn both
the screen and the handle set off when not in
use.
• Make sure the screen is fully charged before
operation.

maintenanCe

Your D WALT inspection camera has been designed
e
to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and
regular cleaning.
The charger and battery pack are not serviceable.
There are no serviceable parts inside.
Cleaning
WARNING: Blow dirt and dust off with
clean, dry air at least once a week. To
minimize the risk of eye injury, always
wear proper eye protection when
performing this.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHarGer CleaninG instrUCtions
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.

optional accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
accessories should be used with this
product.
reCommended aCCessories
• DCT4101 – 17 mm diameter camera cable
• DCT4102 – 9 mm diameter camera cable
• DCT4105 – 5.8 mm diameter camera cable
• DCT4103 – 1 7 mm diameter, 0.9 m long cable
extension
• Hook and magnet DCT410 (available only as
spare parts)
• Hook, magnet and mirror DCT411 (available
only as spare parts)
Consult your dealer for further information on the
appropriate accessories.

troubleshooting

• Make sure the 10.8 V battery is charged.
• Make sure the screen is fully charged.
• Make sure the screen is always attached to
the handle set. The picture may freeze if you
attempt to remove the screen from the handle
set while taking a photo or video.
• M ake sure the battery is installed on the handle
set when in use.
E ng l i s h
WALT, have
e
WALT recommended
e
15