Cradlepoint mbr1200 User Manual page 30

User Manual / MBR1200B
Remote Identity: Specifies the identifier we expect to receive from the remote host during phase 1
negotiation. If no identifier is defined then no verification of the remote peer's identification will be done.
Currently we only support identifiers in the form of an IP address, a user-fully qualified domain name (user@
mydomain.com) or just a fully qualified domain name (www.mydomain.com). If left blank we will default to the
IP address of the WAN connection. If NAT-T is being used, a single word (instead of an address) can be used if a
DynDNS connection is not being used.
Authentication Mode: Select from Pre-Shared Key and Certificate. Pre-Shared Key is used when there is a
single key common to both ends of the VPN. Certificate requires the creation of a set of certificates and a
private key that can be uploaded to the router. Select Enable Certificate Support in the Global VPN Settings
section to upload a single set of certificates for the router to use.
Pre-Shared Key: Create a password or key. The routers on both sides of the tunnel must use this same key.
Protocol: Upper-layer protocol to be matched. The following protocols can be set: ICMP, TCP, UDP, GRE or Any.
Any includes all of the previously mentioned protocols.
Initiation Mode: Always On or On Demand. Always On
is used if you want the tunnel to initiate the tunnel
connection whenever the WAN becomes available.
Select On Demand if you want the tunnel to initiate a
connection if and only if there is data traffic bound for
the remote side of the tunnel.
Enable Tunnel: Enabled or Disabled.
Add/Edit Tunnel – Local Gateway
IP Version: Select IPv4 or IPv6.
WAN Binding: WAN Binding is an optional parameter
used to configure the VPN tunnel to ONLY operate when
the specified WAN device(s) are available and connected.
An example use case is when there is a router with both a primary and failover WAN device and the tunnel
should only be used when the system has failed over to the backup connection.
Make a selection for "When," "Condition," and "Value" to create a WAN Binding. The condition will be in the
form of these examples:
When
Port
Type
• When:
• Port – Select by the physical port on the router that you are plugging the modem into (e.g., "USB
Port 2").
• Manufacturer – Select by the modem manufacturer (e.g., "Cradlepoint Inc.").
• Model – Set your rule according to the specific model of modem.
• Type – Select by type of Internet source (Ethernet, LTE, Modem, Wireless as WAN, WiMAX).
• Serial Number – Select a 3G or LTE modem by the serial number.
• MAC Address – Select a WiMAX modem by MAC Address.
• Unique ID – Select by ID. This is generated by the router and displayed when the device is connected
to the router.
• Condition: Select "is," "is not," "starts with," "contains," or "ends with" to create your condition's
statement.
Condition
Is
Is not
©2016 Cradlepoint. All Rights Reserved.
Value
USB Port 1
WiMax
| +1.855.813.3385 | cradlepoint.com
5/3/16
30