Advertisement
ET5200PpH-DR
Hardened IP CCTV Self-Configured 5-port 10/100/1000Base-T with 4-port PoE+ Ethernet Switch
Wall-mount Installation
1. Remove the screws to
take out the DIN rail clip
from the switch.
Setup
1.
Connect one end of each Ethernet cable to its corresponding port on the ET5200PpH-DR. Connect
the other end to the network equipment (IP camera, Switch or PC).
Connect the ET5200PpH-DR to the power supply. Ensure the power supply in connected to a power
2.
source and the PWR indicator is ON. If not, please ensure that the power cable is connected
properly and the power supply is functioning normally.
After all cables are connected, the indicators will be lit as per port status LEDs (page 4).
Interface
RJ-45 Pin Assignment
2. Tighten the screws to affix the
wall mount plate and the switch
together.
3. Mount the switch on the wall
or on a flat surface with 2 screws
through the mounting holes to
secure it into position.
Pin
Signal Name
1
TP0+ Positive (VCC+)
2
TP0-
Positive (VCC+)
3
TP1+ Negative (VCC-)
4
TP2+
5
TP2-
6
TP1-
Negative (VCC-)
7
TP3+
8
TP3-
3
Mounting
Holes
V1.1
Advertisement
