On/Off; Mode; Fan Speed; Buttons - Braemar BSHV25D1S Owner's Manual

OPERATION cont.
ON / OFF
Press to turn the power on or off.
SLEEP function will be cancelled when
power is turned off.

MODE

Press to toggle between AUTO,
COOL, DRY, FAN and HEAT modes.
The remote controller & indoor will
display the below icons:-
AUTO Mode - cycles between
COOL and HEAT modes
depending on ambient
temperature.
COOL Mode - refrigerated cooling
DRY mode - for extracting
moisture from the air.
FAN mode - Fan only operation
(no cooling).
HEAT mode - reverse cycle
heating.
AUTO mode is the default setting.
During AUTO mode, the SET
temperature will not be Note: to
prevent cold air after starting HEAT
mode, unit will blow air after a 1-5
minute delay.
6
.
BSHVD1S Series High Wall Inverter Unit

FAN SPEED

Press the FAN button to toggle
between AUTO, Low, Medium and
High speed.
AUTO
AUTO fan speed is default on power
up. In DRY mode, only Low FAN
speed is selected.
/

BUTTONS

▲ ▼
Use to adjust the SET temperature
within the range 16-30°C (61-86°F).
Hold the button down for quick
adjustment.
Note: Temperature adjustment is
unavailable in AUTO mode.

CLOCK

Press the CLOCK button to set the
clock time. ¹ will flash on the display,
and the clock can be adjusted by
pressing the or
▲
seconds, using a 24 hr clock. Once
the correct time is set, press the
CLOCK button again to confirm the
¹
clock setting. will be displayed
continuously, this indicates the clock
time is set. Set the correct time to
enable the TIMER function to work
correctly.
buttons within 5
▼