Advertisement
leakSMART
Professional Installation Steps
Water Flow
Open
Close
12
™
5.
The valve will also need to reach an AC power source. It is recommended
that the valve is kept operating on AC power (cord provided), with
batteries used as a back-up power source.
IMPORTANT: The valve must be installed after the water main manual
shut-off and water meter. It is recommended that the valve be installed at
least 8 inches away from water shut-off to avoid damage. Additional fittings
may be required.
•
Do not solder fittings near the water meter
•
Position the valve so that the arrow on the side points away from
the water meter.
6.
Once installed, close the faucet, turn on the main water valve and check
for leaks. Reattach the valve cover by sliding it over the motor housing,
with the front facing you.
7 .
Attach the AC power cord adapter to the valve cover and plug into the
nearest 110 volt outlet.
•
Using an extension cord is not recommended — please use the
10 ft. AC power adapter cord in this package.
•
An optional 9 ft. AC power adapter extension wire is also available.
This, and other leakSMART
getleaksmart.com
8.
Check valve cover function by turning on a faucet and pressing
the "Open" and "Close" buttons.
•
When the valve is open, it will display a steady green light and
water will run.
•
When the valve is closed, it will display a steady red light and water
will stop running.
Confirm the valve can now be paired with the leakSMART
and hub.
accessories, can be purchased at
™
Sensor(s)
™
Advertisement
