PowerWasher h1610 User Manual page 22

PROBLEM OR CONCERN
No water coming out of
Wand
Trigger will not move
Unit will not start
Note: Unit will only start when
trigger is depressed.
Unit stops while operating
Unit will not stop when trigger
is released
POSSIBLE CAUSE
Gun/Hose Assembly is defective Attach the Gun/Hose to the front of the unit with
Gun Safety Lock in engaged
Unit is not turned on
Loose or disconnected Plug
Defective GFCI Plug
Extension Cord length or gauge
incorrect
Gun trigger not operating
properly
Defective Gun
Tripped Pressure washer
Thermal Switch
Defective ON/OFF Switch
Screen filter is clogged
Garden Hose is kinked or
leaking water
SOLUTION
no wand attached to the Gun.
Squeeze the trigger of the gun to ensure that water
comes out of the front of the Gun at a rate equal
to the Garden Hose. If no water comes out of the
Gun, remove the gun and the hose to ensure that
water flows out of the pump. If it does, the gun will
need to be replaced. Contact us at:
customerservice@hdpowerwasher.com
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.hdpowerwasher.com
www.huskypowerwasher.com.
Release Safety Lock as instructed in Manual.
Press ON/OFF Switch into ON position.
Reconnect Plug.
If the GFCI does not work it will need to be re-
placed. Contact us at:
customerservice@hdpowerwasher.com customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
www.hdpowerwasher.com
Use proper Extension Cord as instructed in section
4.3.
Contact us at:
customerservice@hdpowerwasher.com customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.hdpowerwasher.com www.huskypowerwasher.com.
Remove the Gun and Hose assembly from the
front of the unit. Aim water stream away from
electric source and switch the unit into the ON
position. If the unit starts and water comes out
of the front, the Gun may need to be replaced.
Contact us at:
customerservice@hdpowerwasher.com
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.hdpowerwasher.com www.huskypowerwasher.com.
Allow to cool and restart unit.
Contact us at:
customerservice@huskypowerwasher.com customerservice@hdpowerwasher.com
or order a replacement directly online at:
www.hdpowerwasher.com
www.huskypowerwasher.com.
Clean the Screen filter as instructed in the section
6.4.
Make sure the Garden Hose is laid out flat and
there are no kinks in it. The hose should not be
wrapped on a storage wheel. Make sure the
faucet is open all the way and there is a full
volume of water reaching the unit.

22
H1610