Philips HX8915/01 User Manual page 26

ENGLISH
Note: When the Philips Sonicare is used in clinical studies, the default 2-
minute Clean mode with high intensity must be selected. The handle should
be fully charged and the Easy-start feature deactivated.
Brushing modes
Clean mode
The ultimate in plaque removal (default mode).
White mode
To brighten and polish your front teeth.
1 Press the power on/off and mode button to switch on the Philips
Sonicare.
2 Press the power on/off and mode button again before 2.5
seconds to switch to White mode.
3 Press the power on/off and mode button after 2.5 seconds to
pause the Philips Sonicare.
Intensity levels
Low: 1 LED indicator light
-
Medium: 2 LED indicator lights
-
High: 3 LED indicator lights
-
Note: To adjust the intensity level to the next higher or lower level, press the +
intensity level button to increase intensity or the - intensity level button to
decrease intensity at any time during the brushing cycle.
Battery status (when handle is not on charger)
- A flashing yellow battery level indicator with 3 beeps indicates a low
charge.
- A flashing green battery level indicator indicates a moderate charge.
- A solid green battery level indicator indicates a full charge.
Note: If you hear two sets of 5 beeps and the battery level indicator flashes
yellow, this means that you have to recharge the battery. When the battery is
completely empty, the Philips Sonicare switches off. Place the Philips Sonicare
on the charger to charge it (Fig. 3).
25