Table of Contents
Advertisement
Hardware Problems
Symptom
Graphic image prints partly on
one page, partly on the next.
When you try to print nothing
happens, but printer indicates it
is ready to receive data.
"Garbage" prints.
Printer freezes or displays error
message when computer is
rebooted.
Odours.
Printer is on but must "warm up"
before a job is printed.
Problem
Insufficient printer memory for this image at this
resolution.
Configuration error.
Incorrect cable configuration.
(Also, see "Software Problems.")
Booting the computer while the printer is on can
cause a communications error.
Gases are given off by forms or adhesives passing
through the hot fusing unit.
Power Save mode is set on to conserve energy. The
fuser must heat up before you can begin printing
the next job.
Solution
Change the resolution, reduce the image size,
or install more memory in your printer.
Check cable connection. If more than one printer
is available, make sure your printer has been
selected.
Check cable configuration, continuity, and length.
Turn printer off before rebooting computer.
Make sure the forms you use can withstand
heating, and provide adequate ventilation.
To eliminate warm up delay, change Power Save
setting in the soft control panel.
Advertisement
Table of Contents
