Table of Contents
Advertisement
n DIP switch
SW No.
-
Always ON
-
Auto Cutter *
-
Always ON
-4
Command emulation
-5
USB mode *
-6
colors printing
-
Reserved
-
Print head model *
* The factory settings for enabling/disabling the auto cutter are as follows.
Models without auto cutter: Invalid (Switch - = on)
Models with auto cutter: Valid (Switch - = off)
Note: Do not enable the auto cutter for models without the auto cutter (i.e., models with a
tear bar). A mechanical error will occur.
* USB interface model only
* Do not change the default setting (Switch - = off).
Function
– –
ON
Should be set on
Invalid
Should be set on
Star
Printer class
Valid
pin wire
OFF
Valid
ESC/POS
Vendor class
Invalid
pin wire
Advertisement
Table of Contents
