Table of Contents
Advertisement
* Automatically the printer is recovered if the cutter returns to the home position after turn-
ing the power OFF and ON.
Restoration is also possible with the <DLE> <ENQ> n command when in the ESC/POS
mode.
Note
) If the cutter doesn't return to the home position, or doesn't perform the initial move-
ment, it cannot be recovered.
) If the paper is jammed, turn the power OFF, clear the jammed paper, then turn the
power ON.
) When the error occurs:
STAR Mode: Non recoverable error
ESC/POS Mode: Recoverable error
* Turn the power OFF, clear the jammed paper or remedy another problem and then turn
the power ON. Automatically the printer is recovered if the carriage returns to the home
position after turning the power OFF and ON.
Restoration is also possible with the <DLE> <ENQ> n command when in the ESC/POS
mode.
When the error occurs:
STAR Mode: Non recoverable error
ESC/POS Mode: Recoverable error
* For paper jam errors:
Clear the jammed paper and change the paper roll if necessary.
For incorrect paper format errors:
Change the paper roll and use a paper roll with the correct black mark.
) Non recoverable error
Error Description
Flash memory write
error
Thermistor failure
error
Power supply error
CPU error
RAM R/W error
Note
If a non-recoverable error occurs, turn the power OFF, wait at least 0 seconds, and turn
the power back ON. If the non-recoverable error continues to be indicated, consult a dealer
for repairs.
POWER lamp
ERROR lamp
Off
Flashes (On: sec./
Off: sec.)
Off
Flashes (On: 0.5
sec./Off: 0.5 sec.)
Off
Flashes (On: sec./
Off: sec.)
Off
On
Off
On
Buzzer
None
short beeps (0. sec. + 0.5 sec.)
None
One long beep ( sec.)
None
– –
Advertisement
Table of Contents
