Unregister; Reset Unit; Set Prefix - BELGACOM Twist 109 User Manual

Note
If no action is taken on the handset within
10 seconds, the registration procedure will
be aborted. If this happens, repeat Step 1.
If no base is found within a certain period,
an error beep is emitted to indicate failed
registration and the handset returns to idle
mode.
8.3

Unregister

m
1
Press
:
to
ADVANCED SET
<
, scroll
OK
<
and press
2
Enter the Master PIN when
prompted and press
confirm.
:
3
Scroll to select the handset
number to unregister and press
<
.
OK
• A validation tone is emitted to indicate
successful unregistration and the
screen returns to previous menu.
Note
If no action is taken on the handset within
15 seconds, the unregistration procedure
will be aborted and the handset returns
to idle mode.
To unregister a handset that does not
belong to your new phone range, you can
only use your new phone to unregister it.
8.4

Reset unit

You can reset your phone to its default
settings with this feature.
!
Warning
Upon reset, all your personal settings, call
log and redial list entries will be deleted
28
key in idle mode, scroll
and press
:
to
UNREGISTER
.
OK
<
to
OK
and the phone will return to its default
settings. However, your phonebook will
remain unchanged after reset.
Note
You may have to configure your phone
once again. In this case the language
selection menu will appear again after
master reset. (see chapter 3.4)
m
1
Press
:
to
ADVANCED SET
<
, scroll
OK
<
press
OK
2
is displayed on the screen.
CONFIRM?
<
3
Press
OK
• A validation tone is emitted.
• The unit is reset to its default
settings. (see "Default settings" on
chapter 8.8)
8.5

Set prefix

This feature allows you to define a prefix
number to be added to the beginning of a
number during predialling (see
"Predialling" on chapter 4.1.1). You may
also use this feature to add a detect string
to match and replace the first few digits of
the number during predialling.
You can enter up to a maximum of 5
digits for the detect string and auto prefix
number respectively.
m
1
Press
:
to
ADVANCED SET
<
, scroll
OK
<
and press
2
DETECT DIGIT
screen. Press
• The last stored detect string is
displayed (if any).
key in idle mode, scroll
and press
:
to
RESET
.
again to confirm.
key in idle mode, scroll
and press
:
to
AUTO PREFIX
.
OK
is displayed on the
<
to enter.
OK
Advanced settings
and