Berkel CC34 Service Manual page 6

Fig. 8
6. Remove drive belt, screw, washer, and knife
shaft pulley.
Fig. 9
7. Remove three Torx screws and bearing cover.
Fig. 10
NOTE: Carefully turn top housing over to gain access
to the knife shaft. Do not pinch or bend wires when
removing screw from knife shaft.
F25264 (0116)
Food Processer - REMOVAL AND REPLACEMENT OF PARTS
8. Remove screw pin from knife shaft.
NOTE: Some heat may be required to remove the
screw pin.
9. Remove seal ring from knife shaft.
10. Tap knife shaft assembly from top housing.
11. Remove roll pin from knife shaft assembly.
12. Remove two bearings from knife shaft.
13. Remove lock ring from knife shaft.
Page 6 of 13
Fig. 11
Fig. 12