Oki ML5521 User Manual page 39

Paper Out Override, Default = No
Senses when less than 1" (25 mm) of paper remains and stops
printing. Change to Yes to override the sensor and print closer to the
bottom of the page.
Engaging Paper Out Override can cause loss of data and damage the
printhead by allowing printing without paper.
Parity, Default = None
Appears only when the optional Serial Interface is installed. Selects
the type of parity your system uses: None, Odd or Even.
Pin 18, Default = +5V
Sets the signal on pin 18 to +5 volts or open.
Pitch, Default = 10 cpi
Choose the character width in characters per inch (cpi).
Power Save Time, Default = 5 min.
Sets the interval the printer waits for more data before it goes into the
power save mode. Power Saving must be set to Enable (the factory
default) for this to be effective.
Power Saving, Default = Enable
Change to Disable if you wish to prevent the printer from entering the
Power Save mode after the selected interval.
Print Mode, Default = Utility
Choose the quality and typeface of printing. Switch to NLQ Courier or
NLQ Gothic for Near Letter Quality printing. If you are printing
draft-type documents, select DRAFT, then select either HSD or SSD
under DRAFT Mode. Both of these Items are in the Font Group.
CAUTION!
MENU MODE > 39