Forms Tear-Off set to ON
With paper loaded and the printer ON and selected:
1
2
1.
Press PARK (6) to park the paper.
The SEL light goes off and the red alarm light comes on.
2.
Press FF | LOAD (4) to load the paper.
3.
Wait briefly until the paper moves up to the tear position, then
press and hold TEAR (5).
The paper moves to the current TOF and the SEL light is
illuminated.
4.
If the printer is ON line, press SEL
printer OFF line.
The SEL light goes out.
5.
Hold down SHIFT (2), then:
Press LF | Micro Feed Down (3) to set the TOF higher (the
l
paper moves down).
Press FF/LOAD | Micro Feed Up (4) to set the TOF lower
l
(the paper moves up).
(When you begin pressing the Micro Feed key, the printhead will move
to the right).
6.
Press SEL | MENU (1) to save the setting and place the printer
back on line.
To reset the Top of Form to the factory default, see the next page.
3
4
USING YOUR PRINTER > 17
5
6
MENU (1) to take the
|
7