Oki Microline 8480FB User Manual page 11

Combined Switches
With the Printer Powered Up and Off Line
Switches
+
MODE.jpg
SHIFT.jpg
Memory Auto ALign Cross Ref
+
SEL.jpg
SHIFT.jpg
+
SHIFT.jpg
FF.jpg
+
SHIFT.jpg
LF.jpg
Task Performed
Select Align 1, Align 2, Align 3, or Align 4:
Press and hold the MODE switch, then press the
SHIFT switch repeatedly to select Align 1, Align 2,
Align 3, or Align 4 as the setting for Auto Align (see
page 41).
• Auto Align (POW) [see page 42] must be set to
SelectAutoALign (the default).
• The setting made using these switches is stored
in Memory Auto Align (see page 47) unless it has
been changed to Invalid.
Enter the Function Setting Menu:
Press both the MODE and the SHIFT switches
simultaneously to place the printer in the Function
Settings Menu mode.
Simultaneously press and hold the SHIFT and SEL
switches to move continuous forms up to the tear
off position (see page 61).
Note: Form Tear Off must be engaged. The
factory default is Off.
Press and hold SHIFT, then press FF repeatedly to
move loaded paper (single sheets or continuous
forms) forward 1/180-inch at a time.
If you press and hold SHIFT, then press and hold
LF, the paper will advance in rapid-fire 1/180-inch
increments.
Press and hold SHIFT, then press LF repeatedly to
move loaded paper (single sheets or continuous
forms) backward 1/180-inch at a time. Maximum
allowed backward movement is 1/3-inch (8.5 mm).
If you press and hold SHIFT, then press and hold
LF, the paper will advance backward in rapid-fire
1/180-inch increments.
Microline 8480FB User's Guide
Control Panel • 11