Function Code C: Insert Cartridge Into Tape Drive; Function Code E: Test Cartridge And Media - IBM Ultrium Gen 6 Installation And User Manual

2. Press the Unload button once per second until
cycle past the desired code, press the Unload button once per second until the
code reappears.)
3. Press and hold the Unload button for 3 or more seconds, then release it to
select the function.
erases all errors from the error code log and exits Maintenance mode.

Function code C: Insert cartridge into tape drive

You cannot select this function; it is part of other maintenance functions (such as
Run tape drive diagnostics and Create FMR tape) that require a tape cartridge to
be inserted.

Function code E: Test cartridge and media

Approximate Run Time = 15 minutes per loop
Total Number of Loops = 10
Function code
magnetic tape are acceptable.
Press the Unload button to stop the diagnostic and exit Maintenance mode.
Pressing the Unload button once will abort the test at the end of the current test
loop. Pressing the Unload button twice will abort the test immediately. Wait for the
drive to rewind the tape and unload the cartridge.
Attention: When you perform this test, data on the suspect tape will be
overwritten.
Note: If you inserted an invalid tape cartridge (e.g., Ultrium 3 or WORM tape
cartridge), error code
write-protected cartridge, or the media has read-only compatibility (e.g., Ultrium 4
tape cartridge), error code
unloads the cartridge and exits Maintenance mode after the cartridge is removed.
To execute Function code E: Test cartridge & media, complete the following steps:
1. Put the drive in Maintenance mode. For instructions, see "Entering
Maintenance mode" on page 27.
2. Press the Unload button once per second until
cycle past the desired code, press the Unload button once per second until the
code reappears.)
3. Press and hold the Unload button for 3 or more seconds, then release it to
select the function. The SCD changes to a flashing
4. Make sure that the write-protect switch on the cartridge is off, then insert the
cartridge (or the tape drive exits Maintenance mode). The SCD changes to
flashing
v If no error is detected, the diagnostic will loop and begin again. To stop the
loop, press the Unload button for one second and release. When the
diagnostic ends,
Maintenance mode.
flashes in the SCD, followed by
performs tests that determine whether a suspect cartridge and its
or appears in the SCD. If you inserted a
appears in the SCD. In either case, the tape drive
. The tape drive runs the tests.
temporarily appears in the SCD, and the tape drive exits
appears in the SCD. (If you
. The tape drive
appears in the SCD. (If you
, requesting a cartridge.
Chapter 3. Operations
35