Saab 1987 900 Owner's Manual page 94

SERVICE STATION INFORMATION
To open hood:
T
J
""t"
o remove
19n1
Ion
key:
Recommended fuel:
EngineOi1:
Gearbox Oil:
Coolant:
Power Steering:
Tires:
Tune-up
information:
Towing disabled
vehicle:
Pull hood release lever (located under left side of instrument panel). Press the front
edge of hood down slightly and release safety catch. Allow fi'ont of hood to rise and
move forward, then tilt entire hood forward. To close hood tilt rearward and reverse
the above procedure.
(Close slowly until safety catch engages, then push firmly to latch.)
Engage Reverse (manual) or Park (automatic) and turn key to "L" (lock).
Key switch is located on center console.
Unleaded, minimum octane rating 87 or higher. (SPG models require
premium unleaded)
Use only oils meeting both SAE viscosity and API Service classes listed below.
Viscosity - SAE 10W-30 (Alternated - SAE 5W-30, SAE 15W-40 API Service
- Turbo: SF/CD or SF/CC. 900, 900S: SF/CC
Manual- SAE 10W-30, SAE 10W-40 or SAE EP 75, API GL-4 or GL-5 Automatic-
Type "F", M2C33F (Do not use Dexron ATF)
Final Drive (Automatic): SAE EP 80, API GL-4 or GL-5
Saab brand coolant (BASF G-105) mixed with clean fresh water (minimum 50%
glycol in mix year round).
Use only "GM Specification Power Steering Fluid" (GM 9985919, Texaco TL 4634 or
equivalent.) Do not use ATF.
Pressures: See page 87. Do not tighten wheel nuts with an impact wrench.
See Vehicle Emission Control Information label, left front inner fender.
See recommendations on page 39.
CAUTION: The fuel injection system should be adjusted or serviced only with the proper tools and according to prescribed procedures and only be qualified persons
skilled in Saab Fuel I'liection servicing. Fuel lines must never be cut or spliced and all connections must be properly torqued on reassembly. Tampering
with the Fuel Injection System or Turbocharger. (if equipped) may void warran1y coverage of affected components.
When welding on vehicle, disconnect the alternator. Avoid the plastic fuel tank and lines and all fl ammable materials.