Saab 1987 900 Owner's Manual page 55

Table of Contents

Advertisement

thermostatic switch. The fan
is
only opera-
tive when the temperature of
the
radiator
coolant is higher
than
the cut-in
tempera-
ture
ofthe thermostatic switch.
The radiator fan may continue to run, or
may cut in, for a short while after the
engine has been switched
off.
A timer relay
limits the after-running of
the
radiator fan
to about
10
minutes.
WARNING!
Boiling coolant can cause serious burns.
Let the engine cool before removing pres-
sure cap. The cooling system operates
under pressure. Always open the cap
on
the expansion
tank
slowly and allow any
steam to escape before you remove the
cap. The radiator must not be screened
or blocked off]
Car
care and scheduled maintenance 53
Checking the coolant level
The expansion
tank is transparent
to
facili-
tate checking
ofthe
coolant level. The level
should be between the MAX
and
MIN
marks
on the
tank.
When necessary, top up with the recom-
mended
anti-freeze coolant mixture (see
below). After
an empty expansion tank has
been
filled up, the engine should be run
until warm and the
tank topped
up
again.
NOTE!
Keep the coolant at
the
recom-
mended level. Correct
any
leaks imme-
diately. Operating the engine with low
coolant level may cause damage to the
cylinder head.
Changing coolant
Draining
1. Set the heater control to maximum heat.
2. Loosen the pressure
cap
on the expan-
sion tank.
3. Open radiator drain cock which is loca-
ted towards the bottom of the radiator
on the right hand side.
4. Open engine drain plug located to the
right of the engine, under the exhaust
manifold.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents